What to Send Us

The part itself

Even if it is broken or worn.

Photos

Taken next to a ruler, with a few key measurements.

A drawing or sketch

If you have one.

Make, model or part number

Of the equipment the part comes from.

Not sure what is useful? Send what you have. The first evaluation is free.

How We Make It

Step 1

Project evaluation

We tell you whether the part is a good candidate and what the job involves.

Step 2

Capture

3D scanning, with bores, threads and mating faces measured by hand.

Step 3

CAD model

Worn or broken areas rebuilt from the surrounding geometry.

Step 4

Test fit

A draft part checked on your equipment before the final part is made.

Step 5

Final part

Made in a suitable engineering material and machined where it needs a precise fit.

Better Than the Original

Because the part is modeled from scratch, it does not have to be a straight copy. A weak spot can be thickened, a gear can get a chamfer that helps it engage, and a brittle plastic can be replaced with a tougher material that lasts longer.

  • Garage door opener drive gear (replaces 41A2817 / 41C4220A): remodeled with an added chamfer and made in a tougher, longer-lasting material. See it in the Shop.
  • Pump casing: reverse engineered, then the discharge volute was redesigned for better flow. See the project.

Project Evaluation

Have a part or a problem in mind? Send a few photos or drawings and tell us what the part needs to do. The initial evaluation is free, and we’ll give you a straight answer on whether it’s a good fit. We’d rather understand your needs and build a working relationship than just quote a part.